The high-quality craftsmanship includes finished wells, molded liners and careful penetration of each bulkhead and divider. All wire runs are neat, and fittings are robust. The vents and blowers are powerful. The AC/DC fixtures create such good lighting, a flashlight would be needed only to look under the engine.
Also in this space is the origin of one of the Nordhavn 47's greatest attributes: sound attenuation. It has been shown that during long voyages, excessive sound can cause fatigue, which leads to accidents and clouded judgment. The 47 eliminates this problem with a combination of 3-inch-thick Nidacore and 2-inch foam and lead insulation, along with a dry stack exhaust. The exhaust exits via a double-walled pipe and uses resilient mounts and expansion joints all the way up the spar. This system enhances reliability by eliminating the heat exchanger, though it costs more to rig and consumes interior space. Heat from the engine is released via a keel cooler.
Is it worth the trade-offs? When we first left the dock for our sea trial, I thought my decibel meter was broken or had a dead battery. The 47 exhibited the lowest sound readings of any boat I have tested. Even at full load, the readings were equivalent to those of some express boats at idle. During the long passages Nordhavn owners tend to undertake, this whisper-quiet ride will be invaluable.
Fuel is delivered to the engine via an aluminum supply reservoir; the fuel feeds are at the bottom of the tank, the return on top. A sight gauge can be used to monitor fuel burn, and a sediment trap and water probe are incorporated. The main fuel cells are molded fiberglass, as are all the other tanks, and the entire tank can be checked via an inspection plate. The tank is fully baffled with replaceable chambers-quite an asset during an extended trip or when putting a boat up for sale. A smaller aluminum wing day tank feeds the auxiliary engine.
As you would expect in a Nordhavn, the electrical system is fully redundant. Four alternators provide power, and all can be run in parallel. The 270- and 35-amp alternators run off the main engine, and the 80-amp alternator runs off the Yanmar. A 30-amp alternator is on the generator.
The hull is of solid construction (Leishman was quick to say Pacific Asian Enterprises has never had a structural failure due to grounding). The 47 is strong were it counts. While I was inspecting the forward stateroom, I could hear the voices of the crew on the foredeck, but their footsteps were barely audible.
Her bridge is Portuguese-style and built for the open ocean. The starboard side deck is covered. The bow houses a large Maxwell winch and a watertight Freeman hatch. The forward compartment will hold 400 feet of chain and is structural, but does have a drain into the bilge.
The pilothouse interior is ship-like and set up for long passages. Handling is in keeping with what you would expect from a displacement hull, and the skipper need not strain to look at gauges or shipping lanes. The 47 is steady as she goes, with a detectable yet orderly motion. The Naiad stabilizers do their job, and the large wheel delivers the power. Reduction was increased from 3:1 to 4:1 on this model, and she can spin in slightly less than two boat lengths without the aid of the thruster.
I have read some other reviews of the Nordhavn 47, and they all have the same problem this one does: getting to the end without devoting the proper accolades to the two-stateroom interior's décor, and to overall fit and finish. Consider that a testament to the builder, and check out the accompanying photos to see how the interior lives up to the same standard.
Contact: Pacific Asian Enterprises/ Nordhavn, (949) 496-4848;
